SOFiSTiK Forum

It is currently Mon Oct 14, 2019 6:34 am

All times are UTC




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: AQB - design stresses
PostPosted: Fri May 19, 2017 7:56 pm 
Offline

Joined: Sun Jan 24, 2016 3:35 pm
Posts: 20
Hi there,
I have a following problem: I have created a model of a composite bridge in CSM (different section during construction) and I would like to check stresses in AQB using design combinations with different load factors:
Dead load G_1 – unfovourable factor 1.2; favourable factor 0.9
Superimposted dead load G_2 – unfovourable factor 1.5; favourable factor 0.9
Creep and shrinkage during construction C_1 – unfovourable factor 1.2; favourable factor 0.85
Creep and shrinkage during service C_2 – unfovourable factor 1.2; favourable factor 0.0

I would be grateful if someone could advice me how to set extreme design combinations for stress check in AQB.

What is the best way?

Regards


Top
 Profile  
 
PostPosted: Fri May 26, 2017 5:56 am 
Offline
User avatar

Joined: Mon Jul 12, 2004 8:39 pm
Posts: 50
Location: Maribor, Slovenia
Hi!

In AQB you can set for loads own factors. See AQB manual - COMB command.

I hope this helps!
korpi


Top
 Profile  
 
PostPosted: Fri May 26, 2017 8:07 pm 
Offline

Joined: Sun Jan 24, 2016 3:35 pm
Posts: 20
Hi Korpi,

I have already solved this problem :)

anyway, great thanks for your answear :)

regards,
yhm


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group