SOFiSTiK Forum
http://www.sofistik.com/forum/

Fabric area reinforcement
http://www.sofistik.com/forum/viewtopic.php?f=65&t=8257
Page 1 of 1

Author:  Marko [ Thu Jun 27, 2019 11:11 am ]
Post subject:  Fabric area reinforcement

Hello,

I am having problems modifying fabric area reinforcement (single sheet). Is it possible to trim just one sheet in fabric area. Revit does not trim the fabric inner corners. Thank you.

Attachment:
Mreza.png [46.15 KiB]
Not downloaded yet

Author:  lenabeck [ Fri Jun 28, 2019 7:30 am ]
Post subject:  Re: Fabric area reinforcement

Hi Marko,
thanks for your request. In Revit fabric sheets can only be trimmed by the whole length or width. So it is not possible to cut the inner corner. These modifications have to be made on site.

Kind Regards
Lena

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/