SOFiSTiK Forum

Canked lap splice / Rebar Tag with shape symbols
Page 1 of 1

Author:  ahmedzain12 [ Tue Sep 25, 2018 12:10 pm ]
Post subject:  Canked lap splice / Rebar Tag with shape symbols


i have recently stating using sofstic reinforcement detailing using revit . currently i'm working with huge project . all reinforcement arrangement provided by consultant should include cranked lap . i am trying to do such shape using split tool as following

great rebar set

make model line at cranked position

use split tool with selecting lines and got error which mean you have to connect with the support team .

another question is is possible to make rebar tag with shape code symbols and parameter as shown in my attached pic

eeeee.PNG [ 23.82 KiB | Viewed 6510 times ]

Author:  lenabeck [ Mon Jan 07, 2019 11:45 am ]
Post subject:  Re: Canked lap splice / Rebar Tag with shape symbols

hi ahmedzain12,

the split tool is used for split rebars according to a stock length and places them with the a lap length, not for crank rebars. There's a video how this tool works:
To crank rebars you could edit the sketch.

With the newest version of SOFiSTiK RCD (2019-2) it is possible to add shape symbols to the annotations. You can find the Annotation Options on the ribbon at Tag and Detail (see picture below). The bar segment lengths can only be shown in the shape details.

Hope this helps!

Tag_and_Detail.png [ 21.36 KiB | Viewed 5959 times ]

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group