SOFiSTiK Forum
http://www.sofistik.com/forum/

Cant show Fabric sheets,various error messages
http://www.sofistik.com/forum/viewtopic.php?f=65&t=7287
Page 1 of 1

Author:  mapets [ Wed Apr 04, 2018 9:08 am ]
Post subject:  Cant show Fabric sheets,various error messages

Good day,

I have been using Sofistik Reinforcement Detailing for a while now and I have a few questions:

1. I am putting fabric sheets into a wall. In the corresponding section, I fixed my visibility paramenters to have my fabric sheets and rebar show as I want them to. I apply reinforcement, put tags, and shape Details. As soon as I add the shape details, when I go to draw another fabric, after I close out of sketching mode, the fabric sheet immediately disappears. I can even select it. I don't thing it's a visibility issue, because this happens only i after ai add the shape details. Up until the time I add the tags of the reinforcement, I can add another fabric as usual.
2. I also get this error message:
An internal error occurred. The command cannot be continued.
Please contact our support hotline.
Exception message: Der Objektverweis wurde nicht auf eine Objektinstanz festgelegt.

This happens when I try to get the shape detail of a fabric I put in my section, using the Einzelmatte command. (Basically as an area reinforcement in both sides of a wall)
3.One more error message, when I try to get the shape detail of a bended fabric sheet this time:
An internal error occurred. The command cannot be continued.
Please contact our support hotline.
Exception message: The referenced object is not valid, possibly because it has been deleted from the database, or its creation was undone.



Thank you very much

Author:  mapets [ Fri Apr 20, 2018 2:39 pm ]
Post subject:  Re: Cant show Fabric sheets,various error messages

I figured out what to do with the 1st and the 3rd issue.

But I still dont understand why I can't get a shape image of a fabric in section with the Sofistik_Shape_Code 00.
It works for rebars.
Isn't that the case with fabrics???

Author:  bteutriene [ Thu Sep 13, 2018 10:09 am ]
Post subject:  Re: Cant show Fabric sheets,various error messages

Hello,
It's true, we don't support rebar shape images for fabrics which are not bent. May be it would be a workaround for you to use a tag with a comment "not bent". I will forward your wish to our product management. :D

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/