SOFiSTiK Forum
http://www.sofistik.com/forum/

Sofistik-BIMTOOLS- FormworkArea -Error
http://www.sofistik.com/forum/viewtopic.php?f=65&t=6780
Page 1 of 1

Author:  Dangtiep [ Sat Sep 12, 2015 9:21 am ]
Post subject:  Sofistik-BIMTOOLS- FormworkArea -Error

While calculating formwork quantities, we have an Error and the addin can not finish.
If any one have solution please co-operate.
Thanks,

Attachments:
Capture.PNG
Capture.PNG [ 15.18 KiB | Viewed 13045 times ]

Author:  bteutriene [ Mon Sep 21, 2015 3:06 pm ]
Post subject:  Re: Sofistik-BIMTOOLS- FormworkArea -Error

Hello Dangtiep,

Thanks for your question. This error appears if tiny inaccuracy is found in your project that are smaller than the Revit tolerance. It's not easy to find. The only way is to make a little selection of some elements and THEN use the command. In that case only the formwork area of the selected elements is calculated. Do that step-by-step with all elements.

Tip: Formwork areas are calculated differently depending if neighbouring elements are selected as well.

I hope this answers your question. If you have further questions don't hesitate to answer or open a new thread in our forum. :D

Author:  Bernardo [ Wed Sep 27, 2017 4:05 pm ]
Post subject:  Re: Sofistik-BIMTOOLS- FormworkArea -Error

Hi,

I'm having the same problem and also realized that I could extract formwork element by element. But once I've identified the elements that do not give me any formwork values, in my case, concrete stairs and a rooftop, I'm not able to extract in any way those values.

Do you have any advice on how to adress this problem?

Thank you,

Author:  bteutriene [ Thu Sep 28, 2017 10:43 am ]
Post subject:  Re: Sofistik-BIMTOOLS- FormworkArea -Error

Dear Bernardo,
Thank you for your request. We could just help you by analysing the affected building components. Please send your project to support@sofistik.com with some information about your issue.

Kind regards,
Björn :D

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/