SOFiSTiK Forum

It is currently Mon Oct 21, 2019 5:02 am

All times are UTC




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sat Sep 12, 2015 9:21 am 
Offline

Joined: Sat Sep 12, 2015 7:27 am
Posts: 1
While calculating formwork quantities, we have an Error and the addin can not finish.
If any one have solution please co-operate.
Thanks,


Attachments:
Capture.PNG
Capture.PNG [ 15.18 KiB | Viewed 12780 times ]
Top
 Profile  
 
PostPosted: Mon Sep 21, 2015 3:06 pm 
Offline
User avatar

Joined: Thu Jun 11, 2015 7:39 am
Posts: 153
Location: Nürnberg
Hello Dangtiep,

Thanks for your question. This error appears if tiny inaccuracy is found in your project that are smaller than the Revit tolerance. It's not easy to find. The only way is to make a little selection of some elements and THEN use the command. In that case only the formwork area of the selected elements is calculated. Do that step-by-step with all elements.

Tip: Formwork areas are calculated differently depending if neighbouring elements are selected as well.

I hope this answers your question. If you have further questions don't hesitate to answer or open a new thread in our forum. :D

_________________
Greetings
Björn Teutriene

BiM Consultant | Application Engineer
BiMOTiON GmbH

http://www.bimotion.de


Top
 Profile  
 
PostPosted: Wed Sep 27, 2017 4:05 pm 
Offline

Joined: Wed Sep 27, 2017 3:58 pm
Posts: 1
Hi,

I'm having the same problem and also realized that I could extract formwork element by element. But once I've identified the elements that do not give me any formwork values, in my case, concrete stairs and a rooftop, I'm not able to extract in any way those values.

Do you have any advice on how to adress this problem?

Thank you,


Top
 Profile  
 
PostPosted: Thu Sep 28, 2017 10:43 am 
Offline
User avatar

Joined: Thu Jun 11, 2015 7:39 am
Posts: 153
Location: Nürnberg
Dear Bernardo,
Thank you for your request. We could just help you by analysing the affected building components. Please send your project to support@sofistik.com with some information about your issue.

Kind regards,
Björn :D

_________________
Greetings
Björn Teutriene

BiM Consultant | Application Engineer
BiMOTiON GmbH

http://www.bimotion.de


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group