SOFiSTiK Forum
http://www.sofistik.com/forum/

AQB - design stresses
http://www.sofistik.com/forum/viewtopic.php?f=39&t=7143
Page 1 of 1

Author:  yhm [ Fri May 19, 2017 7:56 pm ]
Post subject:  AQB - design stresses

Hi there,
I have a following problem: I have created a model of a composite bridge in CSM (different section during construction) and I would like to check stresses in AQB using design combinations with different load factors:
Dead load G_1 – unfovourable factor 1.2; favourable factor 0.9
Superimposted dead load G_2 – unfovourable factor 1.5; favourable factor 0.9
Creep and shrinkage during construction C_1 – unfovourable factor 1.2; favourable factor 0.85
Creep and shrinkage during service C_2 – unfovourable factor 1.2; favourable factor 0.0

I would be grateful if someone could advice me how to set extreme design combinations for stress check in AQB.

What is the best way?

Regards

Author:  KORPI [ Fri May 26, 2017 5:56 am ]
Post subject:  Re: AQB - design stresses

Hi!

In AQB you can set for loads own factors. See AQB manual - COMB command.

I hope this helps!
korpi

Author:  yhm [ Fri May 26, 2017 8:07 pm ]
Post subject:  Re: AQB - design stresses

Hi Korpi,

I have already solved this problem :)

anyway, great thanks for your answear :)

regards,
yhm

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/