SOFiSTiK Forum

It is currently Sat Jul 20, 2019 3:54 pm

All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri Sep 14, 2018 11:21 am 
Offline

Joined: Wed Mar 16, 2016 6:09 pm
Posts: 19
Hi

I would have a question about creating a surface SAR with SARR type SWEE that starts with an offset above the reference GID1.

My aim is to model a curved surface that extends between certain Z coordinates, eg. Z1=5 and Z2=10. In Sofiplus-x, I modeled a SLN 1 with the coordinate Z=0, giving the bottom surface reflection - used for GID1. Then there is a vertical sweeping line SLN 2 intended for the GID2. The Z coordinates of SLN 2, are Z1=5 Z2=10. Is it possible to create the surface SAR in such a way that it does not start at the position of GID1 but with the offset of Z=5?

I do not seem to find a solution for how to create the needed offset. (in case the offset is even possible)

of course, solution would be switching the reference lines, but the offset is the thing that I am searching for...

thank you for any ideas!!

Lydia


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group